Dell PowerConnect W-7200 Series Reference Manual page 993

Parameter
GRE call id processing
Session Idle Timeout
Broadcast-filter ARP
WMM content enforcement
Session VOIP Timeout
Stateful H.323 Processing
Stateful SCCP Processing
Only allow local subnets in user
table
Monitor/police CP attacks
Rate limit CP untrusted ucast
traffic
Rate limit CP untrusted mcast
traffic
Rate limit CP trusted ucast traffic
Rate limit CP trusted mcast traffic
Rate limit CP route traffic
Rate limit CP session mirror
traffic
Rate limit CP auth process traffic
Deny inter user traffic
Prohibit ARP Spoofing
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
If active the controller creates a unique state for each PPTP tunnel.
Shows if a session idle timeout interval has been defined.
If enabled, this feature reduces the number of broadcast packets sent
to VoIP clients, thereby improving the battery life of voice handsets.
If traffic to or from the user is inconsistent with the associated QoS
policy for voice, this feature reclassifies traffic to best effort and data
path counters are incremented.
If enabled, a idle session timeout is defined for sessions that are
marked as voice sessions.
Shows if the controller has enabled or disabled stateful H.323
processing.
Shows if the controller has enabled or disabled stateful SCCP
processing.
If enabled, the controller only adds IP addresses which belong to a
local subnet to the user table.
If enabled, the controller monitors a misbehaving user's inbound traffic
rate. If this rate is exceeded, the controller can register a denial of
service attack.
Shows the inbound traffic rate
Displays the untrusted multicast traffic rate limit.
Displays the trusted unicast traffic rate limit.
Displays the trusted multicast traffic rate limit.
Displays the traffic rate limit for traffic that needs generated ARP
requests.
Displays the traffic rate limit for session mirrored traffic forwarded to
the controller.
Displays the traffic rate limit for traffic forwarded to the authentication
process.
If enabled, this setting disables traffic between all untrused users. You
can configure user role policies that prevent Layer-3 traffic between
users or networks but this does not block Layer-2 traffic.
When this option is enabled, possible arp spoofing attacks are logged
and an SNMP trap is sent.
show firewall | 993