Dell PowerConnect W-7200 Series Reference Manual page 1074

Parameter
startup-query-count
startup-query-interval
last-member-query-count
last-member-query-interval
version-1-router-present-timeout
Related Commands
Command
ip igmp
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
1074 | show ip igmp
Description
controller sends a host-query message and when it receives a response.
This must be less than the query-interval.
Number of queries that the controller sends out on startup, separated by
startup-query-interval. The default setting is the value of the robustness-
variable parameter.
Interval, in seconds, at which the controller sends general queries on
startup. The default value of this parameter is 1/4 of the query-interval.
Number of group-specific queries that the controller sends before
assuming that there are no local group members.
Maximum time, in seconds, that can elapse between group-specific query
messages.
Timeout, in seconds, if the controller detects a version 1 IGM router.
Description
This command configures Internet Group Management Protocol (IGMP) timers and counters.
Licensing Command Mode
Base operating system Available in Config or Enable mode on master controllers.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide