Dell PowerConnect W-7200 Series Reference Manual page 1142

show log system
show log system{[<number>][all]}
Description
Show the controller's system logs.
Syntax
Parameter
<number>
all
Example
This example shows the controller's last ten system logs.
(host) #show log system 10
Mar 5 11:55:59 :316073:
Num-WM 0
Mar 5 11:55:59 :316083:
customerissue', current_channel='11', type='generic-ap', ibss='no', phy_type='80211g', rap_
type='interfering', match_mac='00:00:00:00:00:00', power_level='255', status='up' WHERE
id='71575' ;
Mar 5 11:55:59 :316029:
Type:PROBE_RAP_TYPE
Mar 5 11:55:59 :316036:
0
Mar 5 11:55:59 :316032:
00:0b:86:b5:87:c2
Mar 5 11:56:00 :399814:
Mar 5 11:56:00 :326001:
radio 0: pktsIn 0 pktsOut 0 bytesIn 0 bytesOut 0
Mar 5 11:56:00 :326001:
radio 0: pktsIn 0 pktsOut 52107 bytesIn 0 bytesOut 18143486
Mar 5 11:56:01 :326001:
452036609 BYTES 2062458092 INTR 334327351
Mar 5 11:56:02 :399814:
state :3
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
1142 | show log system
Description
Start displaying the log output from the specified number of lines from the end of the log.
Shows all the system logs for the controller.
<DBUG> |wms| Received New AP Message: AP 00:0b:86:b5:87:c2 Status 1
<DBUG> |wms| mysql: UPDATE ap_table SET ssid='qa-abu-
<DBUG> |wms| Sending message to Probe: IP:10.3.49.253 Msg-
AP 00:0b:86:b5:87:c2 Type:1
<DBUG> |wms| Received New STA Message: MAC 00:0b:86:b5:87:c2 Status
<DBUG> |wms| STA Probe: ADD Probe 00:0b:86:a2:e7:40 for STA
<DBUG> |fpapps|
<DBUG> |AP 1.1.1@10.3.49.253 sapd|
<DBUG> |AP 1.1.1@10.3.49.253 sapd|
<DBUG> |AP 1.1.1@10.3.49.253 sapd|
<DBUG> |fpapps|
Licensing
Base operating system
PoE: RAN THRU ITERATION 2
AM: am_read_bss_data_stats:
AM: am_read_bss_data_stats:
AM: MPPS 2722 CPPS 338 PKTS
PoE: Evaluating port 1/5 rv is 0 and crv is 1
Command Mode
Available in Enable and Config modes.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide