Dell PowerConnect W-7200 Series Reference Manual page 759

Column
Slot/Port
High throughput
Mode
Band
Channel
Secondary Channel
EIRP
AP Name
AP Group
Location name
SNMP sysLocation
Master
Gateway
Netmask
IP Addr
Dns IP
Domain Name
Server Name
Server IP
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
this number of seconds of inactivity on the tunnel.
The controller port used by the AP, in the format <slot>/<port>.
The <port> parameter refers to the network interfaces that are
embedded in the front panel of the W-3000 series controller. Port
numbers start at 0, from the left-most position.
Shows if high-throughput (802.11n) features are enabled or disabled.
Shows the operating modes for the AP.
AP: Device provides transparent, secure, high-speed data communications
l
between wireless network devices and the wired LAN.
AM: Device behaves as an air monitor to collect statistics, monitor traffic,
l
detect intrusions, enforce security policies, balance traffic load, self-heal
coverage gaps, etc.
The RF band in which the AP should operate:
802.11g = 2.4 GHz
l
802.11a = 5 GHz
l
Channel number for the AP 802.11a/802.11n physical layer. The available
channels depend on the regulatory domain (country).
The secondary channel number for the AP. The secondary channel is a 20 MHz
channel used in conjunction with the primary channel to create a 40 MHz
channel for high-throughput clients.
High-throughput capable APs use only the primary channel to communicate
with 20 MHz clients. The secondary channel is used for transmissions with 40
MHz capable high-throughput clients.
Current effective Isotropic Radiated Power (EIRP).
Name of the AP.
AP group to which the AP belongs.
Fully-qualified location name (FQLN) for the AP.
User-defined description of the location of the AP, as defined with the command
provision-ap syslocation.
Name or IP address for the master controller.
IP address of the default gateway for the AP.
Netmask for the AP's IP address.
IP address for the AP.
IP address of the DNS server.
Domain name used by the AP.
DNS name of the controller from which the AP boots.
IP address of the controller from which the AP boots
show ap details | 759