Router Ospf - Dell PowerConnect W-7200 Series Reference Manual

router ospf

router ospf
area <area-id>
default-cost <cost>
nssa [default-information no-redistribution | no-summary]
stub [no-summary]
default-information originate always
redistribute vlan [<vlan-ids> | add <vlan-ids> | remove <vlan-ids>]
router-id <rtr-id>
subnet exclude <addr> <mask>
Description
Global OSPF configuration for the upstream router.
Syntax
Parameter
area <area-id>
default-cost <cost>
nssa
default-information-originate
no-redistribution
no-summary
stub [no-summary]
default-information originate
always
redistribute vlan <vlan-ids>
add <vlan-ids>
remove <vlan-ids>
router-id <rtr-id>
subnet exclude <addr> <mask>
Usage Guidelines
OSPFv2 is a dynamic Interior Gateway routing Protocol (IGP) based on IETF RFC 2328. The ArubaOS
implementation of OSPF allows controllers to deploy effectively in a Layer 3 topology. For more detailed
information, refer to the OSPF Chapter in the Dell PowerConnect W-Series ArubaOS User Guide .
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Enter the keyword area followed by the area identification, in dotted
decimal format, to configure an OSPF area.
Set the summary cost of a NSSA/stub area (in route metric)
Range: 0 to 16777215
Set an area as a NSSA
Originate Type 7 default into the NSSA area
Set the NSSA area for no distribution into this NSSA area
Do not send summary LSA into this NSSA area
Set an area as a Total Stub Area and optionally do not send summary
LSA into this area
Control distribution of default information by distributing a default
route.
Redistribute the vlan user subnet.
Add the user VLANs to the list
Remove user VLANs to the list.
Enter the router ID in IP address format.
Specify the subnet that OSPF will not advertise. Enter the subnet and
mask address in dotted decimal format (A.B.C.D).
router ospf | 545