Table of Contents
Advertisement
show interface port-channel
show interface port-channel
Description
Displays information about a specified port-channel interface.
Syntax
Parameter
access-group
counters
untrusted-vlan
xsec
Example
The example below shows the output of show interface port-channel 0 on a controller.
Port-Channel 0 is administratively up
Hardware is Port-Channel, address is 00:00:00:00:00:00 (bia 00:0B:86:F0:36:B1)
Description: Link Aggregate (LACP)
Spanning Tree is disabled
VLAN membership:
Switchport priority: 0
Member port:
Last clearing of "show interface" counters 3 day 21 hr 23 min 6 sec
link status last changed 3 day 21 hr 23 min 6 sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
0 multicast, 0 unicast
0 packets output, 0 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
Port-Channel 0 is NOT TRUSTED
The output of this command includes the following parameters:
Parameter
Port-Channel 0 is...
line protocol is...
Hardware is....
address is...
Description
1048 | show interface port-channel
Description
Displays access groups configured on this interface.
Displays L2 interface counters for the specified interface.
Displays port member vlan untrusted status.
Displays xsec configuration.
1
Description
Status of the specified port.
Status of the line protocol on the specified port.
Hardware interface type.
MAC address of the hardware interface.
The port type, name, and connector type. If the LAG is created by LACP, it
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Advertisement
Table of Contents
