Dell PowerConnect W-7200 Series Reference Manual page 761

Column
Antenna tilt angle for
802.11a
Antenna tilt angle for
802.11g
Mesh SAE
Command History
Release
ArubaOS 3.0
ArubaOS 3.2
ArubaOS 3.4
ArubaOS 5.0
ArubaOS 6.1
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
NOTE: This parameter is supported on outdoor APs only. The horizontal
coverage pattern does not consider the elevation or vertical antenna pattern.
The angle of the 802.11a (5GHz) antenna. This parameter can range from
between -90 degrees and 0 degrees for downtilt, and between +90 degrees and
0 degrees for uptilt.
The angle of the 802.11g (2.4GHz) antenna. This parameter can range from
between -90 degrees and 0 degrees for downtilt, and between +90 degrees and
0 degrees for uptilt.
Shows if the AP has enabled or disabled Secure Attribute Exchange (SAE) on a
mesh network. This setting is disabled by default.
Modification
Command introduced
Introduced support for mesh parameters, additional antenna parameters, and AP
location parameters.
Introduced support for the following parameters:
installation
l
mesh-sae
l
set-ikepsk-by-addr
l
usb-dev
l
usb-dial
l
usb-init
l
usb-passwd
l
usb-tty
l
usb-type
l
usb-user
l
The mesh-sae parameter no longer displays the sae-default setting if the parameter is
disabled. Only the sae-disable option indicates that this parameter is currently in its
default disabled state.
The parameter ip6-addr was added to show data for an IPv6 AP.
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
show ap details | 761