Table of Contents
Advertisement
show remote-node-dhcp-pool
show remote-node-dhcp-pool <remote-node-profile-name>
Description
The output of this command lists shows Remote Node DHCP pool summary information.
Syntax
Parameter
remote-node-profile-name
Usage Guidelines
Each Remote Node profile contains a Remote Node DHCP address pool, which defines a range of IP addresses
allocated for Remote Node controllers at a remote site, and the VLAN to be associated with those addresses. A
remote-node dhcp pool is configured in the remote-note mode.
Use the show remote-node-dhcp-pool command to view a summary of Remote Node address pool information.
Example
This example shows a summary of Remote Node DHCP address pool information.
(host) #show remote-node-dhcp-pool pool1
Remote Node Address Pools
--------------------------------------
Pool Name
Type
---------
----
The output of this command includes the following parameters:
Parameter
Pool Name
Type
Start IP Address
End IP Address
Domain Name
Num Hosts
Related Commands
Command
remote-node-profile
550 | show remote-node-dhcp-pool
Description
Name of the Remote Node profile
Start IP Address
End IP Address
----------------
--------------
Description
Name of the new DHCP pool.
Type of pool. This can be tunnel or vlan.
IP addresses at the start and end of the Remote Node's address range, in dotted-decimal format.
IP address at the end of the Remote Node's address range, in dotted-decimal format.
The DHCP domain name.
Maximum number of hosts supported by a Remote Node using this pool.
Description
The remote-node-profile command lets you create a
Remote Node profile.
Domain Name
Num Hosts
-----------
---------
Mode
Config mode
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Advertisement
Table of Contents
