Dell PowerConnect W-7200 Series Reference Manual page 1359

Parameter
Advertise 802.11K
Capability
Forcefully disassociate
on-hook voice clients
Measurement Mode for
Beacon Reports
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Shows if the profile has enabled or disabled the 802.11K feature.
If enabled, the AP may forcefully disassociate clients that reach the maximum CAC peak
capacity or call handoff reservation.
Shows the profile's beacon measurement mode:
active: In this mode, the client sends a probe request to the broadcast destination
l
address on all supported channels, sets a measurement duration timer, and, at the
end of the measurement duration, compiles all received beacons or probe response
with the requested SSID and BSSID into a measurement report.
beacon-table: In this mode, the client measures beacons and returns a report with
l
stored beacon information for any supported channel with the requested SSID and
BSSID. The client does not perform any additional measurements. This is the default
beacon measurement mode.
passive: In this mode, the client sets a measurement duration timer, and, at the end
l
of the measurement duration, compiles all received beacons or probe response with
the requested SSID and BSSID into a measurement report.
Licensing
Base operating system
Command Mode
Enable and Config mode on master or local controllers.
show wlan dot11k-profile | 1359