Dell PowerConnect W-7200 Series Reference Manual page 930

show crypto-local ipsec-map
show crypto-local ipsec [tag <ipsec-map-name>]
Description
Displays the current IPsec map configuration on the controller.
Syntax
Parameter
tag <ipsec-map-name>
Usage Guidelines
The command show crypto-local ipsec displays the current IPsec configuration on the controller.
Examples
The command show crypto-local ipsec-map shows the default map configuration along with any specific IPsec map
configurations.
(host) #show crypto-local ipsec-map
Crypto Map Template"default-local-master-ipsecmap" 9999
IKE Version: 1
PFS (Y/N): N
Transform sets={ default-ml-transform }
Peer gateway: 0.0.0.0
Interface: VLAN 0
Source network: 0.0.0.0/0.0.0.0
Destination network: 0.0.0.0/0.0.0.0
Pre-Connect (Y/N): N
Tunnel Trusted (Y/N): Y
Forced NAT-T (Y/N): N
Crypto Map Template"testmap" 3
lifetime: [300 - 86400] seconds, no volume limit
PFS (Y/N): N
Transform sets={ default-transform }
Peer gateway: 0.0.0.0
Interface: VLAN 0
Source network: 0.0.0.0/0.0.0.0
Destination network: 0.0.0.0/0.0.0.0
Pre-Connect (Y/N): N
Tunnel Trusted (Y/N): N
Forced NAT-T (Y/N): N
Related Commands
Command
crypto-local ipsec-map
930 | show crypto-local ipsec-map
Description
Display a specific IPsec map.
lifetime: [300 - 86400] seconds, no volume limit
IKE Version: 1
Description
Use this command to configure IPsec mapping for site-
to-site VPN.
Mode
Config mode
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide