Dell PowerConnect W-7200 Series Reference Manual page 753

show ap debug system-status
show ap debug system-status {ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>}
Description
Show detailed system status information for an AP.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
Usage Guidelines
The output of this command displays the following types of information (if it exists) for the selected AP:
Bootstrap information
l
Descriptor Usage
l
Interface counters
l
MTU discovery
l
ARP cache
l
Route table
l
Interface Information
l
The following parameters are included in the output of this command, and can help troubleshoot problems on an AP
or wireless network.
Parameter
The Failed column in the Descriptor
Usage section
Interface Information table
AP Uptime table
Tunnel Heartbeat table
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Show system status data for an AP with a specific name.
Show system status data for a specific Basic Service Set Identifier (BSSID) on an AP. The
Basic Service Set Identifier (BSSID) is usually the AP's MAC address.
Show system status data for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
Per-radio statistics
l
Encryption statistics
l
AP uptime
l
memory usage
l
Kernel slab statistics
l
Interrupts
l
Crash Information
l
Description
This parameter can tell you if the AP is dropping packets.
This parameter can tell you if the Ethernet network is working properly. This
table should not show an excessive number of errors.
Low values in this table can indicate problems with the wired network, or with
the AP itself.
This table can indicate the health of the underlying wired network.
Ethernet duplex/speed settings
l
Tunnel heartbeat stats
l
Boot version
l
LMS information
l
Power status
l
CPU type
l
CPU usage statistics
l
show ap debug system-status | 753