Dell PowerConnect W-7200 Series Reference Manual page 744

show ap debug received-config
show ap debug received-config {ap-group <ap-group>|ap-name <ap-name>|bssid <bssid>|ip-addr
<ip-addr>}
Description
Show the configuration the AP downloaded from the controller.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
Example
The output of this command displays configuration information for each interface. The example below shows only
part of the output for this command. Additional parameters not displayed are described in the table below.
(host) #show ap debug received-config ap-name AP12
Downloaded Config for WIFI 0
----------------------------
Item
----
BSSID
LMS IP
Master IP
Mode
QBSS Probe Response
Native VLAN ID
SAP MTU
Heartbeat DSCP
High throughput enable (radio)
Channel
Beacon Period
Transmit Power
Advertise TPC Capability
Enable CSA
CSA Count
Management Frame Throttle interval
Management Frame Throttle Limit
Active Scan
VoIP Aware Scan
Power Save Aware Scan
Load aware Scan Threshold
40 MHz intolerance
Honor 40 MHz intolerance
Legacy station workaround
744 | show ap debug received-config
Description
Show log information for an AP with a specific name.
Show log information for a specific Basic Service Set Identifier (BSSID). The Basic Service
Set Identifier (BSSID) is usually the AP's MAC address.
Show log information for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
Value
-----
10.6.2.250
10.100.103.2
AP Mode
Allow Access
1
1500 bytes
0
Enabled
40-
100 msec
15 dBm
Disabled
Disabled
4
1 sec
20
Disabled
Enabled
Enabled
1250000 Bps
Disabled
Enabled
Disabled
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide