Dell PowerConnect W-7200 Series Reference Manual page 533

Parameter
spectrum-profile <profile>
tpc-power
tx-power
Usage Guidelines
This command configures radios that operate in the 2.4 GHz frequency band, which includes radios utilizing the
IEEE 802.11b/g or IEEE 802.11n standard. Channels must be valid for the country configured in the AP regulatory
domain profile (see
To view the supported channels, use the show ap allowed-channels command.
Examples
The following command configures APs to operate in AM mode for the selected dot11g-radio-profile named
"sampleg:"
rf dot11g-radio-profile sampleg
mode am-mode
The following command configures APs to operate in high-throughput (802.11n) mode on the
2.4 Ghz frequency band for the selected dot11g-radio profile named "sampleg" and assigns a high-throughout radio
profile named "default-g:"
rf dot11g-radio-profile sampleg
high-throughput-enable
ht-radio-profile default-g
The following command configures a primary channel number of 1 and a secondary channel number of 5 for 40 MHz
mode of operation for the selected dot11g-radio profile named "sampleg:"
rf dot11g-radio-profile sampleg
channel <1+>
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
monitors to examine the radio frequency (RF)
environment in which the Wi-Fi network is
operating, refer to the Spectrum Analysis chapter
of the Dell PowerConnect W-Series ArubaOS User
Guide.
Specify the rf spectrum profile used by hybrid APs
and spectrum monitors. This profile sets the
spectrum band and device ageout times used by a
spectrum monitor or hybrid AP radio. For details,
see "rf spectrum-profile" on page
The transmit power advertised in the TPC IE of
beacons and probe responses. Range: 0-51 dBm
Sets the initial transmit power (dBm) on which the
AP operates, unless a better choice is available
through either calibration or from RF Plan.
This parameter can be set from 0 to 51 in .5 dBm
increments, or set to the regulatory maximum
value of 127 dBm.
Transmission power may be further limited by
regulatory domain constraints and AP capabilities.
"ap regulatory-domain-profile" on page
542.
146).
Range Default
— default
0-51 dBm 15 dBm
0-51 dBm, 127 14 dBm
dBm
rf dot11g-radio-profile | 533