Overriding Individual Lines In An Element; Overriding Host Layers - Autodesk 24000-000000-9860 - Revit Architecture - PC User Manual

To exit temporary hide/isolate mode without saving changes:
3 On the View Control Bar, click
To exit temporary hide/isolate mode and make changes permanent:
4 On the View Control Bar, click
If you make temporarily hidden elements permanent, you can reveal them at a later time and unhide them
if necessary. For information, see

Overriding Individual Lines in an Element

You can use the Linework tool to override the line style of individual element lines. For more information,
see Changing the Line Style of Elements

Overriding Host Layers

Using overrides, you can control the visibility of cut edges in host layers in plan and section views. The hosts
to which you can apply an override are walls, roofs, floors, and ceilings. You can assign line weight, line
color, and line pattern to each of the layer functions: Structure, Substrate, Thermal/Air, Finish 1, and Finish
2. You can also control the line styles for common edges, which occur when a line is common to 2 layers
162 | Chapter 4 Project Views
Isolate Element: isolate only the selected elements.
Hide Element: hide only the selected elements.
NOTE You can also access these commands using View menu
use the keyboard shortcuts displayed next to the command in the menu.
When you temporarily hide an element or element category, the drawing area displays with a
blue border, as shown in the following image.
All temporarily hidden elements are restored to the view.
Revealing and Unhiding Hidden Elements
and then click Reset Temporary Hide/Isolate.
and then click Apply Hide/Isolate to View.
on page 326.
Temporary Hide/Isolate, or you can
on page 160.