3Com S7906E Command Reference Manual page 2214

View
Any view
Default Level
1: Monitor level
Parameters
pse pse-id: Specifies a PSE ID. You can use the display poe device command to view the mapping
between PSE ID and slot.
Description
Use the display poe pse interface command to display the state of all PoE interfaces connected to
the specified PSE.
Examples
# Display the state of all PoE interfaces connected to PSE 7.
<Sysname> display poe pse 7 interface
<Sysname> display poe pse 7 interface
Interface Enable
GE2/0/1 enable
GE2/0/2 enable
GE2/0/3 enable
GE2/0/4 enable
GE2/0/5 enable
GE2/0/6 enable
GE2/0/7 disable low
GE2/0/8 disable low
GE2/0/9 disable low
GE2/0/10
GE2/0/11
GE2/0/12
--- 2 port(s) on,
Table 1-7 display poe pse interface command output description
Field
Interface
Enable
Priority
CurPower
Operating
IEEE
Detection
Priority CurPower Operating
(W)
low 4.4
critical 0
low 0
critical 0
low 4.0
low 0
0
0
0
disable low 0
disable low 0
disable low 0
8.4(W) consumed,
Shortened form of a PoE interface
PoE enabled/disabled state. For the value, see
Priority of a PoE interface. For the value, see
Current power of a PoE interface
Operating state of a PoE interface. For the value, see
PD power class
Power detection state of a PoE interface. For the value, see
IEEE Detection
Status class Status
on 1
power-lack -
power-deny -
on -
power-limit 2
power-itself -
off -
off -
off -
off -
off -
off -
171.6(W) Remaining ---
Description
1-11
delivering-power
disabled
disabled
searching
delivering-power
disabled
fault
disabled
disabled
disabled
disabled
disabled
Table 1-2.
Table 1-2.
Table 1-2.
Table 1-2.