3Com S7906E Command Reference Manual page 2295

<Sysname> display vrrp
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Total number of virtual routers: 1
Interface
---------------------------------------------------------------------
Vlan100
# Display detailed information about all VRRP groups on the device.
<Sysname> display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Total number of virtual routers: 1
Interface : Vlan-interface100
VRID : 1
Admin Status : UP
Config Pri : 100
Preempt Mode : YES
Auth Type : NONE
Track IF : Vlan200
Track Object : 1
Track Object : 2
Virtual IP : 10.10.10.2
Virtual MAC : 0000-5e00-0101
Master IP : 10.10.10.1
Table 1-1 display vrrp command output description
Field
Run Method
Virtual IP Ping
Total number of virtual routers
Interface
VRID
Adver. Timer
Admin Status
State
Config Pri
Run Pri
Preempt Mode
Delay Time
Auth Type
VRID State Run
Pri
1 Master 100
Current VRRP running mode, real MAC or virtual MAC
Whether you can ping the virtual IP address of the VRRP group
Number of VRRP groups
Interface to which the VRRP group belongs
Serial number of the VRRP group
VRRP advertisement interval
Administrative state: UP or DOWN
Status of the switch in the VRRP group, master, backup, or
initialize
Configured priority
Running priority
Preemptive mode
Preemption delay
Authentication type
Adver. Auth
Time Type
1 NONE
Adver. Timer : 1
State : Master
Run Pri : 100
Delay Time : 0
Pri Reduced : 10
Pri Reduced : 10
Switchover
Description
1-2
Virtual
IP
10.10.10.2