Mac-Address (System View) - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
dynamic: Dynamic MAC address entries. Aging time is set for these entries.
static: Static MAC address entries. They do not age but you can add or remove them.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted; for example, inputting "f-e2-1" indicates that the MAC address
is "000f-00e2-0001".
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, in the range 1 to 4094.
Description
Use the mac-address command to add or modify a MAC address entry on a specified Ethernet port.
Use the undo mac-address command to remove a MAC address entry on the Ethernet port.
Note that:
As your MAC address entries configuration cannot survive a reboot, save it after completing the
configuration. The dynamic MAC address table entries however will be lost whether you save the
configuration or not.
You cannot configure a static or dynamic MAC address entry on an aggregation port.
Related commands: display mac-address.
Examples
# Add a static entry for MAC address 00e0-fc01-0101 on port GigabitEthernet 2/0/1 which belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] mac-address static 00e0-fc01-0101 vlan 2

mac-address (system view)

Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]
undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id
undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan
vlan-id
undo mac-address [ dynamic | static ] interface interface-type interface-number
View
System view
1-4