Vrrp Configuration Commands For Ipv; Display Vrrp Ipv - 3Com S7906E Command Reference Manual

# Add virtual IP address 10.10.10.11 to VRRP group 1.
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11

VRRP Configuration Commands for IPv6

display vrrp ipv6

Syntax
display vrrp ipv6 [ verbose ] [ interface interface-type interface-number [ vrid virtual-router-id ] ]
View
Any view
Default Level
1: Monitor level
Parameters
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the specified interface.
interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies
a VRRP group by its group number, in the range 1 to 255.
Description
Use the display vrrp ipv6 command to display the state information of VRRP for IPv6.
If you do not specify verbose, only the brief state information of VRRP is displayed.
If you specify both an interface and a VRRP group, only the state information of the specified VRRP
group is displayed; if you only specify an interface, the state information of all the VRRP groups on the
interface is displayed; if you specify neither, the state information of all the VRRP groups on the device
is displayed.
Examples
# Display brief information about all VRRP groups on the device for IPv6.
<Sysname> display vrrp ipv6
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Total number of virtual routers: 1
Interface
---------------------------------------------------------------------
Vlan100
# Display detailed information about all VRRP groups on the device.
<Sysname> display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
: VIRTUAL-MAC
VRID State
1 Master
: VIRTUAL-MAC
Run Adver. Auth
Pri Time Type
100 100 NONE
1-14
Virtual
IP
FE80::1