Info-Center Monitor Channel - 3Com S7906E Command Reference Manual

address of the specified interface. If you want to display the source IP address in the log information,
you can configure it by using this command.
Note that:
The info-center loghost source command takes effect only after the information center is
enabled with the info-center enable command.
The IP address of the specified source interface must be configured; otherwise, although the
info-center loghost source command can be configured successfully, the log host will not receive
any log information.
Examples
# Configure interface VLAN-interface 1 as the egress interface to output log information to the log host.
<Sysname> system-view
[Sysname] info-center loghost source Vlan-interface 1

info-center monitor channel

Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
View
System view
Default Level
2: System level
Parameters
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the info-center channel name command.
Description
Use the info-center monitor channel command to configure the channel to output system information
to the monitor.
Use the undo info-center monitor channel command to restore the default channel to output system
information to the monitor.
By default, output of system information to the monitor is enabled with a default channel name of
monitor and a default channel number of 1.
Note that the info-center monitor channel command takes effect only after the information center is
enabled with the info-center enable command.
Examples
# Set to output system information to the monitor through channel 0.
<Sysname> system-view
1-17