3Com S7906E Command Reference Manual page 2254

Default Level
2: System level
Parameters
interval: Interval between two consecutive tests, in milliseconds, in the range 0 to 604800000. If the
interval is 0, it indicates that only one test is performed.
Description
Use the frequency command to configure the interval between two consecutive tests for a test group.
Use the undo frequency command to restore the default.
By default, the interval between two consecutive tests for a test group is 0 milliseconds, that is, only one
test is performed.
After you use the nqa schedule command to start an NQA test, one test is started at interval.
If the last test is not completed when the interval specified by the frequency command is reached, a
new test is not started.
Examples
# Configure the interval between two consecutive tests as 1000 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] frequency 1000
history-records
Syntax
history-records number
undo history-records
View
Any NQA test type view
Default Level
2: System level
Parameters
number: Maximum number of history records that can be saved in a test group, in the range 0 to 50.
1-9