Info-Center Loghost Source - 3Com S7906E Command Reference Manual

facility local-number: The logging facility of the log host. The value can be local0 to local7 and defaults
to local7. Logging facility is mainly used to mark different logging sources, query and filer the logs of the
corresponding log source.
Description
Use the info-center loghost command to specify a log host and to configure the related parameters.
Use the undo info-center loghost command to restore the default configurations on a log host.
By default, output of system information to the log host is disabled. When it is enabled, the default
channel name will be loghost and the default channel number will be 2.
Note that:
The info-center loghost command takes effect only after the information center is enabled with
the info-center enable command.
Ensure to input a correct IP address while using the info-center loghost command to configure
the IP address for a log host. System will prompt an invalid address if the loopback address
(127.0.0.1) is input.
A maximum number of 4 hosts (different) can be designated as the log host.
Examples
# Set to output log information to a Unix station with the IP address being 1.1.1.1/16.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1

info-center loghost source

Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Default Level
2: System level
Parameters
interface-type interface-number: Specifies the egress interface for log information by the interface type
and interface number.
Description
Use the info-center loghost source command to specify the source IP address for log information.
Use the undo info-center loghost source command to restore the default.
By default, the interface for sending log information is determined by the matched route, and the
primary IP address of this interface is the source IP address of the log information.
After the source IP address of log information is specified, no matter the log information is actually
output through which physical interface, the source IP address of the log information is the primary IP
1-16