Nqa Server Tcp-Connect - 3Com S7906E Command Reference Manual

Description
Use the nqa server enable command to enable the NQA server.
Use the undo nqa server enable command to disable the NQA server.
By default, the NQA server is disabled.
Related commands: nqa server tcp-connect, nqa server udp-echo.
Examples
# Enable the NQA server.
<Sysname> system-view
[Sysname] nqa server enable

nqa server tcp-connect

Syntax
nqa server tcp-connect ip-address port-number
undo nqa server tcp-connect ip-address port-number
View
System view
Default Level
2: System level
Parameters
ip-address: IP address specified for the TCP listening service on the NQA server.
port-number: Port number specified for the TCP listening service on the NQA server, in the range 1 to
50000.-
Description
Use the nqa-server tcp-connect command to create a TCP listening service on the NQA server.
Use the undo nqa-server tcp-connect command to remove the TCP listening service created.
Note that:
You need to configure the command on the NQA server for TCP tests only.
The IP address and port number must be consistent with those on the NQA client and must be
different from those for an existing listening service.
The IP address must be that of an interface on the NQA server. Otherwise, the configuration will be
invalid.
Related commands: nqa server enable.
Examples
# Create a TCP listening service by using the IP address 169.254.10.2 and port 9000.
<Sysname> system-view
[Sysname] nqa server tcp-connect 169.254.10.2 9000
1-30