ntp-service broadcast-server
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
View
Interface view
Default Level
2: System level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to
broadcast clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
version number: Specifies the NTP version, where number is in the range of 1 to 3 and defaults to 3.
Description
Use the ntp-service broadcast-server command to configure the device to work in the NTP broadcast
server mode.
Use the undo ntp-service broadcast-server command to remove the configuration.
Examples
# Configure the device to work in the broadcast server mode and send NTP broadcast messages on
VLAN-interface 1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-server authentication-keyid 4 version 3
ntp-service in-interface disable
Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
Interface view
Default Level
2: System level
Parameters
None
1-8