3Com S7906E Command Reference Manual page 2192

Default Level
2: System level
Parameters
module-name: Specifies the output rules of the system information of the specified modules. For
instance, if information on ARP module is to be output, you can configure this argument as ARP. You
can use the info-center source ? command to view the modules supported by the device.
default: Specifies the output rules of the system information of all the modules allowed to output the
system information, including all the modules displayed by using the info-center source ? command.
debug: Debugging information.
log: Log information.
trap: Trap information.
level severity: Specifies the severity of system information, refer to
keyword, you can specify the severity level of the information allowed/denied to output.
state state: Configures whether to output the system information, which could be on (enabled) or off
(disabled). With this keyword, you can specify whether to output the specified system information.
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the info-center channel name command.
Description
Use the info-center source command to specify the output rules of the system information.
Use the undo info-center source command to remove the specified output rules.
By default, the output rules for the system information are listed in
This command can be used to set the filter and redirection rules of log, trap and debugging information.
For example, the user can set to output log information with severity higher than warnings to the log
host, and information with severity higher than informational to the log buffer. The user can also set to
output trap information of the IP module to a specified output destination.
Note that:
If you do not use the module-name argument to set output rules for a module, the module uses the
default output rules or the output rules set by the default keyword; otherwise the module uses the
output rules separately set for it.
If you use the default keyword to set the output rules for the modules without specifying the debug,
log, and trap keywords, the default output rules for the modules are used. Refer to
details.
If you use the module-name argument to set the output rules for a module without specifying the
debug, log, and trap keywords, the default output rules for the module are as follows: the output of
log and trap information is enabled, with severity being informational; the output of debugging
information is disabled, with severity being debugging. For example, if you execute the command
info-center source snmp channel 5, the command is actually equal to the command info-center
source snmp channel 5 debug level debugging state off log level informational state on trap
level informational state on.
Table
1-19
Table 1-4 for details. With this
1-9.
Table 1-9 for