Vrrp Un-Check Ttl; Vrrp Vrid Preempt-Mode - 3Com S7906E Command Reference Manual

By default, a VRRP group responds to the ping packets destined for its virtual IP address.
Perform this configuration before configuring a VRRP group.
Examples
# Configure a VRRP group to respond to the ping packets destined for its virtual IP address.
<Sysname> system-view
[Sysname] vrrp ping-enable

vrrp un-check ttl

Syntax
vrrp un-check ttl
undo vrrp un-check ttl
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the vrrp un-check ttl command to disable TTL check on VRRP packets.
Use the undo vrrp un-check ttl command to enable TTL check on VRRP packets.
By default, TTL check on VRRP packets is enabled.
Examples
# Disable TTL check on VRRP packets.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp un-check ttl

vrrp vrid preempt-mode

Syntax
vrrp vrid virtual-router-id preempt-mode [ timer delay delay-value ]
undo vrrp vrid virtual-router-id preempt-mode [ timer delay ]
View
Interface view
Default Level
2: System level
1-8