Display Ntp-Service Status - 3Com S7906E Command Reference Manual

Field
reach
poll
now
offset
delay
disper
[12345]
Total associations
When a device is working in the NTP broadcast/multicast server mode, the display ntp-service
sessions command executed on the device will not display the NTP session information corresponding
to the broadcast/multicast server, but the sessions will be counted in the total number of associations.

display ntp-service status

Syntax
display ntp-service status
View
Any view
Default Level
1: Monitor level
Parameters
None
Reachability count of the clock source. 0 indicates that the clock
source in unreachable.
Poll interval in seconds, namely, the maximum interval between
successive NTP messages.
The length of time from when the last NTP message was received or
when the local clock was last updated to the current time
The time is in second by default. If the time length is greater than 2048
seconds, it is displayed in minute; if greater than 300 minutes, in hour;
if greater than 96 hours, in day.
The offset of the system clock relative to the reference clock, in
milliseconds
the roundtrip delay from the local device to the clock source, in
milliseconds
The maximum error of the system clock relative to the reference
source.
1: Clock source selected by the system, namely, the current reference
source, with a system clock stratum level less than or equal to 15
2: Stratum level of the clock source is less than or equal to 15.
3: This clock source has passed the clock selection process.
4: This clock source is a candidate clock source.
5: This clock source was created by a configuration command.
Total number of associations
1-2
Description