Snmp-Agent Trap Source - 3Com S7906E Command Reference Manual

Default Level
3: Manage level
Parameters
size: Number of traps that can be stored in the trap sending queue, in the range 1 to 1,000.
Description
Use the snmp-agent trap queue-size command to set the size of the trap sending queue.
Use the undo snmp-agent trap queue-size command to restore the default queue size.
By default, up to 100 traps can be stored in the trap sending queue.
After traps are generated, they will be saved into the trap sending queue. The size of the queue
determines the maximum number of the traps that can be stored in the queue. When the size of the trap
sending queue reaches the configured value, the newly generated traps are saved into the queue, and
the earliest ones are discarded.
Related commands: snmp-agent trap enable, snmp-agent target-host, snmp-agent trap life.
Examples
# Set the maximum number of traps that can be stored in the trap sending queue to 200.
<Sysname> system-view
[Sysname] snmp-agent trap queue-size 200

snmp-agent trap source

Syntax
snmp-agent trap source interface-type interface-number
undo snmp-agent trap source
View
System view
Default Level
3: Manage level
Parameters
interface-type interface-number: Specifies the interface type and interface number.
Description
Use the snmp-agent trap source command to specify the source IP address contained in the trap.
Use the undo snmp-agent trap source command to restore the default.
By default, SNMP chooses the IP address of an interface to be the source IP address of the trap.
Upon the execution of this command, the system uses the primary IP address of the specified interface
as the source IP address of the traps, and the NMS will use this IP address to uniquely identify the agent.
Even if the agent sends out traps through different interfaces, the NMS uses this IP address to filter all
traps sent from the agent.
Use this command to trace a specific event by the source IP address of a trap.
1-26