Vrrp Vrid Track - 3Com S7906E Command Reference Manual

Before executing the command, create a VRRP group on an interface and configure the virtual IP
address of the VRRP group.
Switches in the same VRRP group must use the same Adver_Timer setting.
Examples
# Set the master in VRRP group 1 to send VRRP advertisements at intervals of five seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-Vlan-interface2] vrrp vrid 1 timer advertise 5

vrrp vrid track

Syntax
vrrp vrid virtual-router-id track track-entry-number [ reduced priority-reduced | switchover ]
undo vrrp vrid virtual-router-id track [ track-entry-number ]
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id: VRRP group number, in the range 1 to 255.
track track-entry-number: Specifies a Track object to be monitored by its number. track-entry-number
ranges from 1 to 1024.
reduced priority-reduced: Specifies the value by which the priority decreases. priority-reduced ranges
from 1 to 255 and defaults to 10.
switchover: Switchover mode of a switch. If the status of the monitored Track object turns to negative
and the switch is a backup in the VRRP group, it turns to the master immediately.
Description
Use the vrrp vrid track command to specify the Track object to be monitored. If the status of the
monitored Track object changes to negative, the priority of the switch decreases by a specified value or
the switch immediately switches to the master.
Use the undo vrrp vrid track command to cancel the specified Track object.
By default, no Track object is specified to be monitored.
Note that:
Before executing the command, create a VRRP group on an interface and configure the virtual IP
address of the VRRP group.
When the switch is the IP address owner, you cannot perform the configuration.
When the status of the monitored Track object turns from negative to positive, the corresponding
switch restores its priority automatically.
1-11