Snmp-Agent Usm-User V - 3Com S7906E Command Reference Manual

equals adding of a new read-only community name. After you add the user name into the read-only
community name field of the NMS, the NMS can establish SNMP connection with the device.
To make the configured user take effect, create an SNMP group first.
Related commands: snmp-agent group, snmp-agent community, snmp-agent usm-user v3.
Examples
# Create a v2c user userv2c in group readCom.
<Sysname> system-view
[Sysname] snmp-agent sys-info version v2c
[Sysname] snmp-agent group v2c readCom
[Sysname] snmp-agent usm-user v2c userv2c readCom
Set the SNMP version on the NMS to SNMPv2c
Fill in the read community name userv2c, and then the NMS can access the agent
# Create a v2c user userv2c in group readCom, allowing only the NMS with the IP address of 1.1.1.1 to
access the agent by using this user name; other NMSs are not allowed to access the agent by using this
user name.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 1.1.1.1 0.0.0.0
[Sysname-acl-basic-2001] rule deny source any
[Sysname-acl-basic-2001] quit
[Sysname] snmp-agent sys-info version v2c
[Sysname] snmp-agent group v2c readCom
[Sysname] snmp-agent usm-user v2c userv2c readCom acl 2001
Set the IP address of the NMS to 1.1.1.1
Set the SNMP version on the NMS to SNMPv2c
Fill in both the read community and write community options with userv2c, and then the NMS can
access the agent.

snmp-agent usm-user v3

Syntax
snmp-agent usm-user v3 user-name group-name [ [ cipher ] authentication-mode { md5 | sha }
auth-password [ privacy-mode { aes128 | des56 } priv-password ] ] [ acl acl-number ]
undo snmp-agent usm-user v3 user-name group-name { local | engineid engineid-string }
View
System view
Default Level
3: Manage level
Parameters
user-name: User name, a string of 1 to 32 characters. It is case sensitive.
group-name: Group name, a string of 1 to 32 characters. It is case sensitive.
1-28