Snmp-Agent Community - 3Com S7906E Command Reference Manual

Description
Use the snmp-agent calculate-password command to convert the user-defined plain text password to
a cipher text password.
Note that:
The cipher text password converted with the sha keyword specified in this command is a string of
40 hexadecimal characters. For an authentication password, all of the 40 hexadecimal characters
are valid; while for a privacy password, only the first 32 hexadecimal characters are valid.
Enable SNMP on the device before executing the command.
When creating an SNMPv3 user, if you specify to use the cipher text authentication/encryption
password, you can use this command to generate a cipher text password.
The converted password is associated with the engine ID, namely, the password is valid only under the
specified engine ID based on which the password was configured.
Related commands: snmp-agent usm-user v3.
Examples
# Use local engine ID and MD5 authentication protocol to convert the plain text password authkey.
<Sysname> system-view
[Sysname] snmp-agent calculate-password authkey mode md5 local-engineid
The secret key is: 09659EC5A9AE91BA189E5845E1DDE0CC

snmp-agent community

Syntax
snmp-agent community { read | write } community-name [ acl acl-number | mib-view view-name ] *
undo snmp-agent community community-name
View
System view
Default Level
3: Manage level
Parameters
read: Indicates that the community has read only access right to the MIB objects; that is, the NMS can
perform read-only operations when it uses this community name to access the agent.
write: Indicates that the community has read and write access right to the MIB objects; that is, the NMS
can perform read and write operations when it uses this community name to access the agent.
community-name: Community name, a string of 1 to 32 characters.
acl acl-number: Associates a basic ACL with the community name. acl-number is in the range 2,000 to
2,999. By using an ACL, you can configure to allow or prohibit the access to the agent from the NMS
with the specified source IP address.
mib-view view-name: Specifies the MIB view name associated with community-name, where
view-name represents the MIB view name, a string of 1 to 32 characters. If no keyword is specified, the
default view is ViewDefault (The view created by the system after SNMP agent is enabled).
1-13