Source Interface - 3Com S7906E Command Reference Manual

View
DLSw, FTP, HTTP, ICMP-echo, SNMP, TCP, UDP-echo, UDP-jitter test type view
Default Level
2: System level
Parameters
None
Description
Use the route-option bypass-route command to enable the routing table bypass function to test the
direct connectivity to the direct destination.
Use the undo route-option bypass-route command to disable the routing table bypass function.
By default, the routing table bypass function is disabled.
Note that after this function is enabled, the routing table is not searched, and the packet is directly sent
to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route

source interface

Syntax
source interface interface-type interface-number
undo source interface
View
ICMP-echo test type view
Default Level
2: System level
Parameters
interface-type interface-number: Interface type and the interface number of the source interface of a
probe packet.
Description
Use the source interface command to specify the IP address of an interface as the source IP address
of ICMP-echo probe requests.
Use the undo source interface command to remove the IP address of an interface as the source IP
address of ICMP-echo probe requests.
1-22