[Sysname-Ethernet2/0/1] apply poe-profile name abc
poe max-power (system view)
Syntax
poe max-power max-power [ pse pse-id ]
undo poe max-power [ pse pse-id ]
View
System view
Default Level
2: System level
Parameters
max-power: Maximum power in watts of the PSE. Support for the range and default value of this
argument depends on the device model.
pse pse-id: Specifies a PSE ID.
Description
Use the poe max-power command to configure the maximum power for the PSE.
Use the undo poe max-power command to restore the default maximum power of the PSE.
The default maximum power of the PSE is 806 watts.
Note that:
The maximum power of the PSE must be greater than or equal to the sum of the maximum
power of all critical PoE interfaces on the PSE so as to guarantee the power supply to these PoE
interfaces. When the consumption power of all PDs connected to the PSE is greater than the
maximum power of the PSE, some PDs will be powered off.
The sum of the maximum power of all PSEs cannot exceed the maximum PoE power.
Related commands: poe priority (system view).
Examples
# Set the maximum power of PSE 7 to 150 watts.
<Sysname> system-view
[Sysname] poe max-power 150 pse 7
poe mode
Syntax
poe mode { signal | spare }
undo poe mode
View
PoE interface view, PoE-profile file view
1-27