Ntp- D226 Install And Close The Fmec Cover - Cisco ONS 15454 SDH Procedure Manual

Chapter 1 Install the Shelf and FMECs
To route twisted-pair cables, tie-wrap or lace the twisted-pair cables according to local site practice and
Step 2
route the cables into the side cutouts on either side of the ONS 15454 SDH.
Step 3 Continue with the
Stop. You have completed this procedure.
NTP-D226 Install and Close the FMEC Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Insert the cover carefully onto the left pin of the hinge
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring
spring snaps into place.
78-17194-01
"NTP-D226 Install and Close the FMEC Cover" procedure on page 1-17
This procedure installs and closes the rear cover.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-D219 Open and Remove the FMEC Cover, page 1-7
Required
Onsite
None

NTP- D226 Install and Close the FMEC Cover

(Figure 1-4).
(Figure 1-4). Push the cover onto the right pin until the
Cisco ONS 15454 SDH Procedure Guide, R7.0
as needed.
1-17