Ntp- D62 Test High-Order Circuits - Cisco ONS 15454 SDH Procedure Manual

NTP- D62 Test High-Order Circuits

c.
d.
e.
If you need to create additional drops on the circuit, repeat Steps
Step 23
Click Close. The Circuits window appears.
Step 24
Verify that the new drops appear in the Destination column for the circuit that you edited. If they do not
Step 25
appear, repeat Steps
Complete the
Step 26
Stop. You have completed this procedure.
NTP-D62 Test High-Order Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
where you will test the high-order circuits. If you are already logged in, continue with
From the View menu, choose Go to Network View.
Step 2
Click the Circuits tab.
Step 3
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-66
Port, VC4—Choose the port and/or VC4 from the Port and VC4 drop-down lists. The choice in these
drop-down lists depends on the card selected in Step b. See
options.
The routing preferences for the new drop match those of the original circuit. However, you can
modify the following:
If the original circuit was routed on a protected SNCP path, you can change the nodal diversity
•
options: Nodal Diversity Required, Nodal Diversity Desired, or Link Diversity Only. See
Step 13 for descriptions.
If the original circuit was not routed on a protected path, the Protection Channel Access option
•
is available. See Step 12
Click OK. The new drop appears in the Drops list.
21 through 24, making sure that all options are provisioned correctly.
"NTP-D62 Test High-Order Circuits" procedure on page
This procedure tests a high-order circuit.
Test set capable of optical speeds, appropriate fibers, and attenuators
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX and one of following circuit
procedures:
NTP-D323 Create an Automatically Routed High-Order Circuit, page 6-55
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60
NTP-D190 Create a Unidirectional High-Order Circuit with Multiple
Drops, page 6-63
NTP-D284 Create a Manually Routed VCAT Circuit, page 6-101
NTP-D325 Create an STM Test Circuit around the Ring, page 6-103
Required
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
for a description of the Protection Channel Access option.
Chapter 6 Create Circuits and Low-Order Tunnels
Table 6-2 on page 6-3
21 and 22.
6-66.
at an ONS 15454 SDH on the network
for a list of
Step 2.
78-17194-01