Table of Contents
Advertisement
Chapter 3
Connect the PC and Log into the GUI
NTP-D260 Set Up CTC Computer for Local Craft Connection to the
ONS 15454 SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete one of the CTC computer setup tasks listed in
Step 1
environment.
Table 3-1
CTC Connection Environment
•
•
•
•
•
•
•
Note
78-17194-01
This procedure explains how to set up a PC running Windows or a Solaris
workstation for an onsite local craft connection to the ONS 15454 SDH.
Network interface card (NIC), also referred to as an Ethernet card
Straight-through (CAT-5) LAN cable
NTP-D278 Set Up Computer for CTC, page 3-2
As needed
Onsite or remote
None
CTC Computer Setup for Local Craft Connection to the ONS 15454 SDH
You are connecting from a Windows PC.
You will connect to one ONS 15454 SDH.
You need to access non-ONS 15454 SDH applications
such as ping and tracert (trace route).
You are connecting from a Windows PC.
The CTC computer is provisioned for Dynamic Host
Configuration Protocol (DHCP).
The ONS 15454 SDH has DHCP forwarding enabled.
The ONS 15454 SDH is connected to a DHCP server.
The ONS 15454 SDH does not provide IP
addresses. If DHCP is enabled, it passes DCHP
requests to an external DHCP server.
NTP- D260 Set Up CTC Computer for Local Craft Connection to the ONS 15454 SDH
Table 3-1
CTC Computer Setup Task
DLP-D50 Set Up a Windows PC for Craft
Connection to an ONS 15454 SDH on the
Same Subnet Using Static IP Addresses,
page 17-37
DLP-D51 Set Up a Windows PC for Craft
Connection to an ONS 15454 SDH Using
Dynamic Host Configuration Protocol,
page 17-39
Note
Cisco ONS 15454 SDH Procedure Guide, R7.0
based upon your CTC connection
Do not use this task for initial
node turn-up. Use the task only if
DHCP forwarding is enabled on
the ONS 15454 SDH. By default,
DHCP is not enabled. To enable
it, see the
"NTP-D169 Set Up
CTC Network Access" procedure
on page
4-7.
3-3
Advertisement
Chapters
Table of Contents
