Dlp- D122 Enable Intermediate Path Performance Monitoring - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
Click the Performance tab to view performance monitoring (PM) parameters. Refer to the "Performance
Step 7
Monitoring" chapter in the Cisco ONS 15454 SDH Reference Manual for more PM information, details,
and definitions.
Note
Return to your originating procedure (NTP).
Step 8
DLP-D122 Enable Intermediate Path Performance Monitoring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The monitored IPPM parameters are P-EB, P-BBE, P-ES, P-SES, and P-UAS. For more information
about IPPM parameters, refer to the "Performance Monitoring" chapter in the Cisco ONS 15454 SDH
Reference Manual.
In node view, double-click the STM-N card you want to monitor. The card view appears.
Step 1
See
Step 2 Click the Provisioning > VC4 tabs
78-17194-01
The fields for positive pointer justification count (PPJC) and negative pointer justification count
(NPJC) PM parameters appear white and blank unless pointer justification count performance
monitoring is enabled.
Table 18-3 on page 18-19

DLP- D122 Enable Intermediate Path Performance Monitoring

This task enables intermediate path performance monitoring (IPPM),
which allows you to monitor large amounts of VC4 traffic through
intermediate nodes.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
for a list of STM-N LTE cards.
(Figure 18-8).
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-21