Chapter 5 Turn Up A Network - Cisco ONS 15454 SDH Procedure Manual

NTP- D35 Verify Node Turn-Up
15.
16.
17.
18.
19.
20.
21.
22.
23.
NTP-D35 Verify Node Turn-Up
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Click the Alarms tab.
Step 2
a.
b.
Step 3 Verify that the SW Version and Defaults in the node view status area match the software version and NE
defaults shown in your site plan. If either is not correct, complete the following procedures as needed:
•
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-2
NTP-D218 Provision an Integrated SNCP Dual-Ring Interconnect, page
complete this procedure after you provision an SNCP ring.
NTP-D306 Provision a Traditional MS-SPRing/SNCP Dual-Ring Interconnect, page
needed, complete this procedure after you provision an SNCP and MS-SPRing.
NTP-D307 Provision an Integrated MS-SPRing/SNCP Dual-Ring Interconnect, page
needed, complete this procedure after you provision an SNCP and MS-SPRing.
NTP-D258 Provision an Open-Ended SNCP, page
you provision an SNCP.
NTP-D344 Open-Ended SNCP Acceptance Test, page
after you provision an open-ended SNCP.
NTP-D46 Subtend an SNCP from an MS-SPRing, page
NTP-D47 Subtend an MS-SPRing from an SNCP, page
NTP-D48 Subtend an MS-SPRing from an MS-SPRing, page
NTP-D172 Create a Logical Network Map, page
This procedure verifies that an ONS 15454 SDH is ready for network turn
up before adding it to a network.
None
Chapter 4, "Turn Up a Node"
Required
Onsite
Superuser
"DLP-D60 Log into CTC" task on page
Verify that the alarm filter is not on. See the
page 19-25 as necessary.
Verify that no unexplained alarms appear on the network. If alarms appear, investigate and resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
If the software is not the correct version, install the correct version from the ONS 15454 SDH
software CD. Upgrade procedures are located in a release-specific upgrade document. Follow the
upgrade procedures appropriate to the software currently installed on the node. TCC2/TCC2P cards
can also be ordered with the latest software release.
If the node defaults are not correct, import the network element defaults. Refer to the "Network
Element Defaults" appendix in the Cisco ONS 15454 SDH Reference Manual.
5-34—As needed, complete this procedure after
5-36—As needed, complete this procedure
5-39—Complete as needed.
5-40—Complete as needed.
5-41—Complete as needed.
5-43—Complete as needed.
17-49. If you are already logged in, continue with
"DLP-D227 Disable Alarm Filtering" task on
Chapter 5 Turn Up a Network
5-28—As needed,
5-30—As
5-32—As
78-17194-01