Dlp- D77 Delete A Member From A Vcat Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
f.
g.
Step 11 If you checked Route Automatically in
following substeps. If not, continue with
a.
b.
c.
Click Finish.
Step 12
Note
Return to your originating procedure (NTP).
Step 13
DLP-D77 Delete a Member from a VCAT Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-17194-01
Repeat Steps c through e until the member is provisioned from the source to the destination node
through all intermediary nodes. If you selected Fully Protect Path, you must:
• Add two spans for each SNCP ring or unprotected portions of the member route from the source
to the destination.
• Add one span for each MS-SPRing or 1+1 portions of route from the source to the destination.
• For members routed on SNCP dual-ring interconnect (DRI) topologies, provision the working
and protect paths as well as spans between the DRI nodes.
Repeat Steps a through f for each member.
Click Next.
Review the circuit route. To add or delete a circuit span, choose a node on the circuit route. Blue
arrows show the circuit route. Green arrows indicate spans that you can add. Click a span arrowhead,
then click Include to include the span or Remove to remove the span.
If the provisioned circuit does not reflect the routing and configuration you want, click Back to
verify and change circuit information.
Adding members to a VCAT circuit might take several minutes depending on the complexity of
the network and the number of members to be added.
This task removes a member from a SW-LCAS VCAT circuit on an
FC_MR-4 (enhanced mode) card. This task reduces the size of the VCAT
circuit.
FC_MR-4 card (enhanced mode)
DLP-D60 Log into CTC, page 17-49
A SW-LCAS VCAT circuit with a source or destination on an FC_MR-4
card (enhanced mode) must exist. See
Low-Order Tunnels."
As necessary, complete the
State" task on page 17-72
Locked-enabled,outOfGroup.
As needed
Onsite or remote
Provisioning or higher

DLP- D77 Delete a Member from a VCAT Circuit

Step 7 and checked Review Route Before Creation, complete the
Step 12.
"DLP-D80 Change a VCAT Member Service
to change a SW-LCAS member state to
Cisco ONS 15454 SDH Procedure Guide, R7.0
Chapter 6, "Create Circuits and
17-69