Dlp- D179 Edit The Osi Router Configuration - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
Choose one of the following routing modes:
Step 3
•
•
Note
Although Cisco does not recommend changing the LSP (Link State Protocol Data Unit) buffer sizes, you
Step 4
can adjust the buffers in the following fields:
•
•
Return to your originating procedure (NTP).
Step 5
DLP-D179 Edit the OSI Router Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Chose the router you want provision and click Edit.
Step 2
In the OSI Router Editor dialog box:
Step 3
a.
b.
78-17194-01
End System—The ONS 15454 SDH performs OSI IS functions. It communicates with IS and ES
nodes that reside within its OSI area. It depends upon an IS L1/L2 node to communicate with IS and
ES nodes that reside outside its OSI area.
Intermediate System Level 1/Level 2—The ONS 15454 SDH performs IS functions. It
communicates with IS and ES nodes that reside within its OSI area. It also communicates with IS
L1/L2 nodes that reside in other OSI areas. Before choosing this option, verify the following:
The node is connected to another IS Level 1/Level 2 node that resides in a different OSI area.
–
The node is connected to all nodes within its area that are provisioned as IS L1/L2.
–
Changing a routing mode should be carefully considered. Additional information about OSI ESs
and ISs and the ES-IS and IS-IS protocols are provided in the "Management Network
Connectivity" chapter of the Cisco ONS 15454 SDH Reference Manual.
L1 LSP Buffer Size—Adjusts the Level 1 link state PDU buffer size.
L2 LSP Buffer Size—Adjusts the Level 2 link state PDU buffer size.
This task allows you to edit the OSI router configuration, including
enabling and disabling OSI routers, editing the primary area address, and
creating or editing additional area addresses.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Check or uncheck the Enabled box to enable or disable the router.
Note Router 1 must be enabled before you can enable Routers 2 and 3.
For enabled routers, edit the primary area address, if needed. The address can be between
8 and 24 alphanumeric characters in length.

DLP- D179 Edit the OSI Router Configuration

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-67