Dlp- D233 Edit Sncp Circuit Path Selectors - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
c.
As needed, change the color of the standby span:
Step 5
a.
b.
c.
As needed, return the active and standby spans to their default colors:
Step 6
a.
b.
c.
d.
Step 7 Return to your originating procedure (NTP).
DLP-D233 Edit SNCP Circuit Path Selectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
In the Circuits tab, click the SNCP circuit(s) that you want to edit. To change the settings for multiple
Step 3
circuits, press the Shift key (to choose adjoining circuits) or the Ctrl key (to choose nonadjoining
circuits) and click each circuit that you want to change.
Step 4 From the Tools menu, choose Circuits > Set Path Selector Attributes.
Step 5 In the Path Selectors Attributes dialog box, edit the following SNCP selectors, as needed:
•
•
78-17194-01
Click OK to close the Pick a Color dialog box. If you want to change the standby span color,
continue with Step 5. If not, click OK to save the change and close the Preferences dialog box, or
click Apply to save the change and keep the Preferences dialog box open.
In the Span Colors area, click the colored square that is near the word Standby.
In the Pick a Color dialog box, click the color for the standby span, or click Reset if you want the
standby span to show the last applied (saved) color.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
From the Edit menu, choose Preferences.
In the Preferences dialog box, click the Circuits tab.
Click Reset to Defaults.
Click OK to save the change and close the Preferences dialog box, or click Apply to save the change
and keep the Preferences dialog box open.
This task changes the SNCP signal fail and signal degrade thresholds, the
reversion and reversion time, and the PDI-P settings for one or more SNCP
circuits.
None
NTP-D44 Provision SNCP Nodes, page 5-22
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Revertive—If checked, traffic reverts to the working path when conditions that diverted it to the
protect path are repaired. If not checked, traffic does not revert.
Reversion time (min.)—If Revertive is checked, sets the amount of time that will elapse before
traffic reverts to the working path. The range is 0.5 to 12 minutes in 0.5 minute increments.

DLP- D233 Edit SNCP Circuit Path Selectors

Cisco ONS 15454 SDH Procedure Guide, R7.0
19-29