Cisco ONS 15454 SDH Procedure Manual page 255

Chapter 6 Create Circuits and Low-Order Tunnels
State—Leave the default (IS) unchanged. Ethergroup circuits are always in service.
•
Apply to drop ports—Uncheck this box; states cannot be applied to E-Series ports.
•
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on an SNCP ring, complete the
Step 11
During Circuit Creation" task on page
Click Next.
Step 12
Provision the circuit source:
Step 13
From the Node drop-down list, choose the hub node.
a.
From the Slot drop-down list, choose the Ethernet card where you enabled the single-card
b.
EtherSwitch.
Click Next.
Step 14
Provision the circuit destination:
Step 15
From the Node drop-down list, choose an EtherSwitch circuit endpoint node.
a.
From the Slot drop-down list, choose the Ethernet card where you enabled the single-card
b.
EtherSwitch.
Click Next.
Step 16
Review the VLANs in the Available VLANs list. If the VLAN you want to use appears, continue with
Step 17
Step 19. If you need to create a new VLAN, complete the following steps:
Click the New VLAN button.
a.
In the New VLAN dialog box, complete the following:
b.
•
•
•
Click OK.
c.
Tip
Step 18 In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
move the VLAN to the Circuit VLANs column.
Note
Click Next.
Step 19
Step 20 Confirm that the following information about the hub-and-spoke circuit is correct:
• Circuit name
• Circuit type
Circuit size
•
78-17194-01
VLAN Name—Assign an easily identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 SDH network
supports a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the
All VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Moving the VLAN from Available VLANs to Circuit VLANs forces all the VLAN traffic to use
the shared packet ring you are creating.
NTP- D143 Create an E-Series Hub-and-Spoke Ethernet Configuration
"DLP-D218 Provision SNCP Ring Selectors
19-17.
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-81