Figure 21-2 Network View Alarm Profiles Window - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
Figure 21-2
Right-click anywhere in the profile column to display the profile editing shortcut menu. (Refer to
Step 6
for further information about the Default profile.)
Click Clone in the shortcut menu.
Step 7
Tip
In the New Profile or Clone Profile dialog box, enter a name in the New Profile Name field.
Step 8
Profile names must be unique. If you try to import or name a profile that has the same name as another
profile, CTC adds a suffix to create a new name. Long file names are supported.
Click OK.
Step 9
A new alarm profile (named in
and appears at the right of the previous profile column in the Alarm Profiles window. You can select it
and drag it to a different position.
Note
The Default profile sets severities to standard IEEE settings. If an alarm has an Inherited profile, it
inherits (copies) its severity from the same alarm's severity at the higher level. For example, if you
choose the Inherited profile from the network view, the severities at the lower levels (node, card, and
port) will be copied from this selection. A card with an Inherited profile copies the severities used by the
78-17194-01
Network View Alarm Profiles Window
To see the full list of profiles, including those available for loading or cloning, click Available.
You must load a profile before you can clone it.
Step
Up to ten profiles, including the two reserved profiles, Inherited and Default, can be stored in
CTC.
DLP- D425 Create a New or Cloned Alarm Severity Profile
8) is created. This profile duplicates the default profile severities
Cisco ONS 15454 SDH Procedure Guide, R7.0
Step 9
21-7