Figure - Cisco ONS 15454 SDH Procedure Manual

NTP- D218 Provision an Integrated SNCP Dual-Ring Interconnect
NTP-D218 Provision an Integrated SNCP Dual-Ring Interconnect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the following steps if you have not provisioned the SNCPs that you will interconnect in an
Step 2
SNCP DRI. If the SNCPs are created, continue with Step 3.
a.
b.
Verify that the SNCP DRI interconnect nodes have STM-N cards installed and have fiber connections to
Step 3
the other interconnect node:
•
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-28
This procedure provisions SNCP rings in an integrated DRI topology. In
the integrated DRI, the SNCP STM-N trunk (span) cards for both SNCPs
are installed on the same shelf.
None
NTP-D35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page
Complete the "NTP-D44 Provision SNCP Nodes" procedure on page 5-22
Complete the "NTP-D343 SNCP Acceptance Test" procedure on page 5-24
All SNCPs that will be interconnected must be at the same STM-N rate.
Note
The STM-N cards that will connect the SNCPs must be installed at the interconnect nodes. The
STM-N cards in the SNCP nodes and the interconnect nodes must be the same type.
The interconnect nodes must have the correct fiber connections. An example is shown in
This example shows an SNCP DRI with two rings.
Chapter 5
17-49. If you are already logged in, continue with
to provision the SNCPs.
Turn Up a Network
to test the SNCPs.

Figure

5-8.
78-17194-01