Ntp- D333 Upgrade The Xc-Vxl-10G Card To The Xc-Vxc-10G Card - Cisco ONS 15454 SDH Procedure Manual

NTP- D333 Upgrade the XC-VXL-10G Card to the XC-VXC-10G Card

NTP-D333 Upgrade the XC-VXL-10G Card to the XC-VXC-10G
Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure applies only to XC-VXL-10G cards that are installed in nodes running Software R6.0
Note
and later.
The UNEQ-P alarm is raised during a cross-connect card upgrade if you have E100T-12 or E1000-2
Note
cards installed in the node. The alarm will clear within a few seconds.
Always upgrade the standby cross-connect card. Removing an active cross-connect card can cause a
Caution
protection switch unless a lockout is in place. If the standby card is being upgraded, a lockout is
unnecessary.
Complete the
Step 1
Step 2.
Determine the standby XC-VXL-10G card. The ACT/STBY LED of the standby XC-VXL-10G card is
Step 2
amber, and the ACT/STBY LED of the active XC-VXL-10G card is green.
Note
Physically replace the standby XC-VXL-10G card on the shelf with an XC-VXC-10G card:
Step 3
a.
b.
c.
d.
e.
In node view, click the Maintenance > Cross-Connect tabs.
Step 4
Cisco ONS 15454 SDH Procedure Guide, R7.0
12-4
This procedure upgrades the XC-VXL-10G card to the XC-VXC-10G
card.
Replacement cards
None
As needed
Onsite
Maintenance or higher
"DLP-D60 Log into CTC" task on page
You can also place the cursor on the card graphic in CTC to display a pop-up that identifies the
card as Active or Standby.
Open the XC-VXL-10G card ejectors.
Slide the card out of the slot. This raises the
is complete.
Open the ejectors on the XC-VXC-10G card.
Slide the XC-VXC-10G card into the slot along the guide rails.
Close the ejectors.
On the XC-VXC-10G card, the fail LED above the ACT/STBY LED becomes red, blinks for some
time (20 to 30 seconds), and turns off. The ACT/STBY LED turns amber and remains illuminated.
Chapter 12
17-49. If you are already logged in, continue with
alarm, which will clear when the upgrade
IMPROPRMVL
Upgrade Cards and Spans
78-17194-01