Ntp- D3 Open And Remove The Front Door - Cisco ONS 15454 SDH Procedure Manual

NTP- D3 Open and Remove the Front Door

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
Statement 1006
The shelf, the air ramp, and the E1-75/120 conversion panel are shipped with the ETSI mounting
Note
brackets installed as needed for installation in an ETSI rack. If you want to install the node in a
19-inch(482.6-mm) rack, the ETSI mounting brackets of the shelf and the air ramp need to be replaced
with the 19-inch (482.6-mm) mounting brackets. The 19-inch (482.6-mm) mounting brackets need to be
ordered separately. If required, the mounting brackets of the E1-75/120 conversion panel can be
uninstalled, rotated 90 degrees, and reinstalled to enable 19-inch (482.6-mm) rack mounting.
Complete the necessary rack mount task as applicable:
Step 1
•
•
•
Step 2 Continue with the
Stop. You have completed this procedure.
NTP-D3 Open and Remove the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
1-6
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
DLP-D5 Mount the Shelf Assembly in a Rack (One Person), page 17-4
DLP-D6 Mount the Shelf Assembly in a Rack (Two People), page 17-6
DLP-D7 Mount Multiple Shelf Assemblies in a Rack, page 17-7
"NTP-D3 Open and Remove the Front Door" procedure on page
This procedure opens and removes the front door to access the equipment.
Open-end wrench
Pinned hex key
NTP-D2 Install the Shelf Assembly, page 1-5
Required
Onsite
None
"DLP-D8 Open the Front Cabinet Compartment (Door)" task on page
Chapter 1 Install the Shelf and FMECs
1-6.
17-9.
78-17194-01