Ntp- D146 Test E-Series Circuits - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
NTP-D146 Test E-Series Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
Required/As Needed
Onsite/Remote
Security
Step 1 Complete the
node. If you are already logged in, continue with Step 2.
Step 2 On the shelf graphic, double-click the circuit source card.
Step 3 Click the Provisioning > Port tabs.
Verify the following settings:
Step 4
•
•
•
•
Click the VLAN tab. If the E-Series cards is not in port-mapped mode, verify that the source port is on
Step 5
the same VLAN as the destination port.
Repeat Steps
Step 6
At the destination node, connect an Ethernet test set to the destination port and configure the test set to
Step 7
send and receive the appropriate Ethernet traffic.
78-17194-01
This procedure tests circuits created on E-Series Ethernet cards that are
provisioned for multicard EtherSwitch, single-card EtherSwitch, or
port-mapped mode.
Ethernet test set and appropriate fibers
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX, and one of the following
procedures:
NTP-D191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode), page 6-72
NTP-D192 Create a Circuit for an E-Series Card in Port-Mapped Mode,
page 6-75
NTP-D142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
6-77
NTP-D143 Create an E-Series Hub-and-Spoke Ethernet Configuration,
page 6-80
NTP-D144 Create an E-Series Single-Card EtherSwitch Manual
Cross-Connect, page 6-82
NTP-D145 Create an E-Series Multicard EtherSwitch Manual
Cross-Connect, page 6-85
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Mode—Set to Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
Enabled—Checked.
Priority—Set to the priority level indicated by the circuit or site plan. Priority does not apply to
E-Series cards in port-mapped mode.
Stp State—Checked if Spanning Tree Protocol (STP) is enabled for the circuit. STP does not apply
to E-Series cards in port-mapped mode.
2 through 5 for the destination card.

NTP- D146 Test E-Series Circuits

at the ONS 15454 SDH source Ethernet
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-89