Ntp- D227 Remove And Replace A Card - Cisco ONS 15454 SDH Procedure Manual

NTP- D227 Remove and Replace a Card

Figure 2-3
Faceplate connector
Route the fiber cables into the cable-management tray
Step 5
Route the fiber cables out either side of the cable-management tray through the cutouts on each side of
Step 6
the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Close the fold-down front door when all fiber cables in the front compartment are properly routed.
Step 7
Stop. You have completed this procedure.
NTP-D227 Remove and Replace a Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If you are not logged into CTC and you need to remove a card, remove the card as described in
Step 1
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) using the
Cisco ONS 15454 SDH Troubleshooting Guide.
Cisco ONS 15454 SDH Procedure Guide, R7.0
2-20
Routing Fiber-Optic Cables on the Optical-Card Faceplate
Cable connector
Tx
Rx
Retaining clip
Slot on cable management tray
Fold down faceplate
This procedure removes and replaces cards in the ONS 15454 SDH shelf.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite
Provisioning or higher
Chapter 2 Install Cards and Fiber-Optic Cable
Cutout
(Figure 2-3).
Step 3.
78-17194-01