Cisco ONS 15454 SDH Procedure Manual page 354

NTP- D320 Convert an SNCP to a Two-Fiber MS-SPRing Automatically
Complete the
Step 2
Complete the
Step 3
Complete the
Step 4
that supports the point-to-point or linear ADM span.
Complete the
Step 5
protect cards in all nodes that will be part of the SNCP ring. Alternatively, if additional bandwidth is
needed for CTC management, complete the
Terminations" task on page
Complete the
Step 6
Automatically Routed High-Order Circuit" procedure on page 6-55
one at a time.
If you want to add additional nodes to the SNCP, see the
Note
on page
An SNCP is the default configuration if the cards installed are installed and the DCCs are configured.
Note
Stop. You have completed this procedure.
NTP-D320 Convert an SNCP to a Two-Fiber MS-SPRing
Automatically
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Open-ended SNCP and SNCP dual-ring interconnect (DRI) configurations do not support in-service
Note
topology upgrades.
Before beginning this procedure, you should have a unique ring name to identify the new MS-SPRing
Note
and a unique node ID number for each node on the ring.
Cisco ONS 15454 SDH Procedure Guide, R7.0
13-12
"DLP-D298 Check the Network for Alarms and Conditions" task on page
"DLP-D189 Verify that a 1+1 Working Slot is Active" task on page 18-77
"DLP-D155 Delete a Protection Group" task on page 18-47
"DLP-D363 Provision Regenerator-Section DCC Terminations" task on page 20-68
20-71.
"DLP-D27 Delete Circuits" task on page 17-21
14-10.
This procedure converts a SNCP to a two-fiber MS-SPRing without
disrupting traffic.
None
NTP-D44 Provision SNCP Nodes, page 5-22
As needed
Onsite or remote
Provisioning or higher
Chapter 13
"DLP-D364 Provision Multiplex-Section DCC
and the "NTP-D323 Create an
to delete and recreate the circuits
"NTP-D105 Add an SNCP Node" procedure
Convert Network Configurations
19-83.
for each node.
for each 1+1 protection group
at the
78-17194-01