Ntp- D312 Viewing The Audit Trail Records - Cisco ONS 15454 SDH Procedure Manual

NTP- D312 Viewing the Audit Trail Records

The following parameters are not backed up and restored when you delete the database and restore the
Note
factory settings: node name, IP address, subnet mask and gateway, and IIOP port. If you change the node
name and then restore a backed up database with a different node name, the circuits map to the new
renamed node. Cisco recommends keeping a record of the old and new node names.
Step 1 If you need to install or replace one or more TCC2/TCC2P cards, see the
TCC2/TCC2P Cards" task on page
If you are using Microsoft Windows, complete the
Step 2
the Database and Upload Software (Windows)" task on page
If you are using UNIX, complete the
Step 3
and Upload Software (UNIX)" task on page
Stop. You have completed this procedure.
NTP-D312 Viewing the Audit Trail Records
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
trail log. If you are already logged in, continue with
In node view, click the Maintenance > Audit tabs.
Step 2
Click Retrieve.
Step 3
A window containing the most recent Audit Trail records appears as shown in
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-10
20-22.
"DLP-D245 Use the Reinitialization Tool to Clear the Database
This procedure allows you to view audit trail records. Audit trail records
are useful for maintaining security, recovering lost transactions, and
enforcing accountability. Accountability refers to tracing user activities;
that is, associating a process or action with a specific user.
None
As needed
Onsite or remote
Provisioning
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D244 Use the Reinitialization Tool to Clear
19-47.
19-49.
at the node where you want to view the audit
Step 2.
Chapter 15 Maintain the Node
"DLP-D332 Install the
Figure 15-4.
78-17194-01