Cisco ONS 15454 SDH Procedure Manual page 176

Before You Begin
NTP-D135 Test Low-Order Circuits, page
15.
electrical circuit.
16. NTP-D323 Create an Automatically Routed High-Order Circuit, page
NTP-D324 Create a Manually Routed High-Order Circuit, page
17.
NTP-D190 Create a Unidirectional High-Order Circuit with Multiple Drops, page
18.
as needed.
19. NTP-D62 Test High-Order Circuits, page
high-order optical circuit.
20. NTP-D139 Create a Half Circuit on an MS-SPRing or 1+1 Node, page
procedure as needed to create a half circuit using an STM-N as a destination in a multiplex
section-shared protection ring (MS-SPRing) or 1+1 protection.
NTP-D140 Create a Half Circuit on an SNCP Ring Node, page
21.
a half circuit using an STM-N as a destination in an subnetwork connection protection (SNCP) ring.
NTP-D191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode), page
22.
6-72—Complete as needed.
NTP-D192 Create a Circuit for an E-Series Card in Port-Mapped Mode, page
23.
needed.
NTP-D142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
24.
needed.
NTP-D143 Create an E-Series Hub-and-Spoke Ethernet Configuration, page
25.
needed.
NTP-D144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect, page
26.
6-82—Complete as needed.
27. NTP-D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect, page
6-85—Complete as needed.
NTP-D146 Test E-Series Circuits, page
28.
circuits.
NTP-D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode,
29.
page
NTP-D241 Provision G-Series Ports for Transponder Mode, page
30.
NTP-D149 Test G-Series Circuits, page
31.
SDH circuits.
NTP-D194 Create Overhead Circuits, page
32.
communications channel (DCC) tunnels, create IP-encapsulated tunnels, provision orderwire, or
create user data channel (UDC) circuits.
NTP-D283 Create an Automatically Routed VCAT Circuit, page
33.
NTP-D284 Create a Manually Routed VCAT Circuit, page
34.
NTP-D325 Create an STM Test Circuit around the Ring, page
35.
NTP-D350 Create a Server Trail, page
36.
Table 6-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-2
6-90—Complete as needed.
defines ONS 15454 SDH circuit creation terms and options.
Chapter 6
6-53—Complete this procedure after you create an
6-60—Complete as needed.
6-66—Complete this procedure after you create a
6-70—Complete as needed to create
6-89—Complete this procedure after creating E-Series SDH
6-95—Complete this procedure after creating G-Series
6-96—Complete as needed to create data
6-101—Complete as needed.
6-103—Complete as needed.
6-106—Complete as needed.
Create Circuits and Low-Order Tunnels
6-55—Complete as needed.
6-63—Complete
6-68—Complete this
6-75—Complete as
6-77—Complete as
6-80—Complete as
6-92—Complete as needed.
6-97—Complete as needed.
78-17194-01